Feature:

• Timely replacement: To maintain the superior performance of your vehicle, please change your fuel filter promptly if it is used for more than 20K miles or 12 months, since unfiltered and unreplaced fuel filters in time will cause rapid wear of fuel injection parts
• 99% filterability: Triple filtration material filters out up to 5 microns of contaminants from the fuel to ensure clean oil is delivered to engine components and longer engine life
• Original equipment standard: All parts are 100% rigorously tested before leaving the factory to meet or exceed original equipment standards, so you don't have to worry about your fuel filter leakage
• Package description: 1 FG-1083 Fuel Filter . You can complete the installation yourself for about half an hour to save some installation costs
• Adapted model: F150 Super Duty, F-250 Super Duty, F-350 Super Duty, Explorer, Explorer Sport Trac, Edge, Mustang, SSV Plug-In Hybrid, Thunderbird, Focus, Mountaineer, Aviator, Mark LT, Nautilus, Navigator, LS, MKX, MKZ. 

Fitment

For Ford

• Edge: 2015 - 2023
• Explorer: 2004 - 2010
• Explorer Sport Trac: 2004 - 2005, 2007 - 2010
• F-150: 2006 - 2008
• F-250 Super Duty: 2005 - 2010
• F-350 Super Duty: 2005 - 2010
• Mustang: 2005 - 2020
• Thunderbird: 2003 - 2005

For Lincoln

• Aviator: 2003 - 2005
• Continental: 2017 - 2020
• LS: 2003 - 2006
• MKX: 2016 - 2018
• MKZ: 2017 - 2020
• Mark LT: 2006 - 2008
• Nautilus: 2019 - 2023

Mercury

• Mountaineer: 2003 - 2010

Symptoms Of A Clogged Fuel Filter

1. An engine dying or sputtering while driving, especially when accelerating

2. A rough idling engine

3. The car does not have the power it did

4. The car will not start

5. Very poor gas mileage

6. The Check Engine Light is on

7. The car will not stay cranked

Changing Frame Rail Filter

1. Remove the sensor harness.

2. Remove filter housing with a 1 1/4" socket or 32mm socket or use a strap wrench. Recommended using ​a strap wrench so that you don't shear the plastic housing.

3. Turn 3 times (not to drench yourself in fuel before opening the drain valve), then loosen the yellow drain valve to drain water into a suitable container.

4. Remember to lubricate the new O-ring and reinstall everything

Changing Engine Filter

1. Remove the fuel line keepers on both lines by pushing down the yellow tabs and the keeper will go down out of the way.

2. The other fuel line will come off by squeezing both white tabs inward then remove.

3. Loosen the 7mm nut and use a 7mm socket wrench to loosen the clamp around the filter, twist to the right until it stops then pull upwards, and install following the same steps in reverse order.

When all done with both filters

1. You must cycle the key to the on position 6 times waiting approx 30 seconds each time before trying to start the truck.

2. Turn the ignition key to on, but do not start. Wait 30 seconds until the fuel pump times out, then turn the key back to off. Repeat 6 times.

3. You will probably notice strange noises coming from the fuel system until it is mostly full.