High-quality materials, exquisite craftsmanship, safe, reliable and durable, long service life, complete specifications, convenient and flexible use, and better cost performance.
Can easily detect and set the servo's false position, jitter and neutral position can be connected to two sets of servos or ESCs; MCU control, good stability and high precision. Rotate the knob to detect the servo. If connected to an electronic governor (brush or brushless can be), you can get rid of the remote control device for manual speed control, used to test the governor or motor performance is very practical, without the need to cumbersomely connect the remote control and receiver. It is equivalent to a "manual receiver" function, through the knob, simulating the transmitter rudder.
- The device also can be used as a signal generator for electric speed controller (ESC), then you can test your motor system without using a transmitter and receiver.
- 3 modes to check servos or ESC:
- Manual mode - turn the knob with different speed, check the reaction time
- Neutral mode - make the servo go back to the neutral point
- Automatic mode - make the servo swing like a window wiper with maximum throw
- You can also connect 1-3 ESC to test and compare their reaction time respectively
- Capability to connect 3 servos of the CCPM helicopters and select servos
- It can also connect the servo of airplanes install the steering-box and adjust planes by using such as the neutral mode
- Size: 35*32*14mm
- Adjustment mode: Manual mode, Automatic mode, Neutral mode
- Specification
(1) Output: ≤15mA (5.0)
(2) Input: DC 4.2-6.0V
(3) Output Signal: 1.5ms+0.5ms
Instructions for use.
1, refer to the above picture, the left side of the servo, divided into the upper middle and lower 3 groups, can be connected to three servos; right single row of pins connected to the power supply, close to the side of the negative (see the identifier number), connected to the negative side of the battery, pay attention to not be reversed, if the power supply is connected to the reverse will burn the IC; "S" identifier corresponding to the pin, do not pay attention to. 2.
2. Turn on the power, the blue lights will light up at the same time, and then only the first one on the left, for the manual adjustment potentiometer test; press the button, the middle light, for the return to the test; the third light, the automatic test.
3. test ESC hair and connect the servo the same, test motor need to connect the ESC first! (This tester can not test more than 55 grams of servos!)
