Operating BELIVELIFE Double Cylinders Heavy Duty Portable Air Compressor
MAKE SURE THE VEHICLE'S ENGINE IS RUNNING.
Instructions:
1: This portable tire inflator is equipped with two starting modes (battery clip and cigarette lighter). When one power supply mode fails, the other can be switched to make the product more durable.
2: Limited to use within DC 12V 25A power supply, can not be used in 24V, 36V, 110V and 220V.
3: If the current of the car cigarette lighter is less than 15 A. Please use the battery clamp.
4: Roll out the 12V power cord and plug the power cord into a 12V cigarette lighter socket.
5:Tighten the thread connection onto tire's valve stem.
6: Press (unit) button to choose the display unit of measure. (4 units available: PSI, BAR,KPA,KG/CM2). Adjust your desired pressure.
7: Press (l) button and the compressor will begin to operate. The compressor will automatically shut off once the desired pre-set pressure is reached.
8: Press (ll) button is to turn on the led light and illuminate the surroundings
Pay attention to the following
1: If you start the pump, tire pressure quickly rise to 50-100PSI, it is the air blocked, must immediately remove the screw connector and re-operation.
2: In order to extend the life of the Tire Inflator, Our recommendation is to cool for 4-8 minutes after 20 minutes of work and continue working
Specifications
|
|
Suitable for Cars, Bikes, Motorcycles, RVs, SUVs, ATVs and Trucks. The compressor only operates with a 12-volt electrical system. |
Q: Do car pumps get hot?
A: Our inflatable pump is made of new imported polyether particles at one time, which has the properties of tensile strength, strong tensile force, high tear strength, wear resistance, bending resistance, and penetration resistance.
Our air pumps experience heat. The air tube will experience a slight temperature rise during inflation, but please don't worry, this is normal. Air creates friction during transport. So there will be heat.
In order to extend the life of the Tire Inflator, Our recommendation is to cool for 4-8 minutes after 20 minutes of work and continue working