| Features and Benefits: This new tool from Gunson measures the Camber and Caster angle on the wheel hub or brake disc and allows adjustment to maintain correct wheel alignment and even tyre wear. Camber is defined as the inward or outward tilt of a wheel at the top relative to the vertical position. The Caster angle is the angle between the vertical and the inclination of the king pin when viewed from the side of the wheel. This simple tool can save expensive down time and allows the strut to be returned to the original position or to check the amount of camber change before re-installing Gunson 77137 Trakrite Camber Bar Designed for use with the Gunson 77099 and 77066 with the wheels on and the vehicle sitting on the ground. The camber bar is fully adjustable for wheels up to 18 inch in diameter and designed to hang on the tyre giving hands free operation. Where the vehicle wheel arch is too low for the camber bar to hang on the tyre it can still be used without the top bracket (held in place by hand). For car and light commercial use. Ideal for quick checking of camber, caster and KPI when used with Gunson 77099/77066. Designed in the UK. Gunson 77066 Trakrite Camber Gauge Measures the Camber and Caster angle on the wheel hub or brake disc and allows adjustment to maintain correct wheel alignment and even tyre wear. A useful tool to maintain the correct Camber setting after dismantling and re-assembling of the suspension. Magnetic gauge attachs to the hub or disc brake. Outside diameter 55mm, 130mm total length. Graduates from -6º to +6º. A useful tool to maintain the correct Camber setting after dismantling and re-assembling the suspension. Supplied in a storage case. Helps to save expensive repair and down time. |