eBay

Description:
Input voltage: DC12V

[Product line length]: 105CM (heating sheet to switch) 142CM (switch to electric door lock)

Working temperature: -30°C---+100°C

[Product power]: high-end 25W, mid-range 20W, low-end 15W (the above data are obtained from experiments, the laboratory room temperature is 15-20 ° C, the specific value may fluctuate slightly due to changes in voltage, environment and other objective factors, for reference only)

[product material]: composite fiber heating wire + wear-resistant cloth, (L bracket) stainless steel

[Installation method]: L bracket mirror base fixed

[Wiring method]: red is connected to the positive pole, black is connected to the negative pole (the reversed light does not light up, only heats up)

[Operation instructions]: Power on: the red light, blue light and green light flash once and then turn off

Standby: The red light is breathing and flashing, and the temperature reaches the relative temperature and automatically turns into a blue light

Working status: indicator light is always on (high-end: red light is always on, mid-range: blue light is always on, low-end, green light is always on)

Click the switch key: switch gears

Note: The positive and negative poles are reversed, the switch cannot be used, and the heating element directly heats up

【Product advantages】:

(1) Which heats up faster and is more evenly heated, and has been successfully tested

(2) Built-in intelligent temperature control chip, three-speed adjustable temperature, intelligent temperature control is more convenient

(3) 10 seconds rapid heating, large heating area

(4) IP67 waterproof level, even if the switch and handle cover are soaked in water, they can work normally. When the handle cover needs to be cleaned, only pull out the plug and wash it with water, which is very convenient

【pay attention】:

[1] Please select the appropriate gear according to the ambient temperature. Under low temperature conditions, when the temperature of the electric heating handle cannot be sensed in time and accurately due to the numbness of the hand, please use the low or medium gear first to prevent high temperature burns.

【2】This product is only suitable for motorcycles with 12V battery. Please read the installation diagram carefully before installation. Wrong wiring method will cause damage to components

【3】This product can only be installed on the handlebar of the motorcycle and used with electricity. Before installation, you can use the battery to test whether the product is correctly energized

[4] It is strictly forbidden to work with electricity (empty burning) when not riding to prevent the temperature of the electric handle grip from being too high and damage the handlebar

[5] It is recommended to connect the electric door lock wire for wiring. Most models are black positive and green negative. It is recommended to use a multimeter to measure the specific situation.