MADE IN JAPAN.
HAS THE CODE ON BOARD SEE PICTURE, VERY IMPORTANT YOU MAKE SURE YOU MATCH UP THE NUMBER OF BUTTONS , FCC ID # AND JAPAN OR IT WILL NOT PROGRAM
You can program this yourself no dealer they will not do it but will sell you one of there's. If you do not have an existing remote to verify please call your dealership parts department up act as if your buying one with your vin number in hand, after they give you a price ask for the remote part number and verify with that number to match this.
ALSO ONLY FOUR REMTOES CAN BE PROGRAM INTO THE CAR COMPUTER IN ITS LIFE TIME, SO IF YOU BOUGHT IT USED YOU MAY RUN INTO BEING THE FIFTH REMOTE WHICH CAN BE PROGRAMED AFTER THE CAR COMPUTER REMOTE CODES ARE WIPE AWAY BUT YOU NEED A SPECIAL SCAN TOOL TO DO THAT WHICH ANY GOOD AUTOLOCKSMITH HAS.
2006 Subaru Baja
2006 - 2010 Subaru Forester
2006 - 2011 Subaru Impreza
2005 - 2010 Subaru Legacy
2005 - 2010 Subaru Outback
More Information
Programming Instructions
Step by Step How to Programming Instructions:
Note: A maximum of ONLY 4 remote key fobs can be programmed at one time. Deactivate alarm if fitted. Locate and record the remote ID number either from the package if new or open up remote if used and there will be an 8 digit code that will be needed to program remote.
Open drivers door enter vehicle and close drivers door.
Within 15 seconds turn key to the ON position and back to LOCK 10 times. An acoustic signal is emitted once to indicate programming mode has been activated. Another continuous acoustic signal will follow and interior lamp will flash until programming is complete.
Note: If an error occurs during programming, the acoustic signal will stop, the interior lamp will go out and the programming will need to be started again.
Within 45 seconds:Open and close driver's door. An acoustic signal is emitted until the ID number is entered.
Press the LOCK button on the door panel the same number of times as the first digit on the remote ID code.
When the digit has been entered press the UNLOCK button on the door panel.
Repeat procedure with each digit in the remote ID code counting from left to right.
Repeat programming procedure for the entire ID number a second time.
An acoustic signal is emitted once to indicate programming complete.
Repeat ID number entering procedure for any additional remotes to be programmed and test remotes.
msrp 160.31
FCC Number NHVWB1U711
OE Part # 88036FE041
Programming Instructions
Step by Step How to Programming Instructions:
Note: A maximum of 4 remote key fobs can be programmed at one time. Deactivate alarm if fitted. Locate and record the remote ID number either from the package if new or open up remote if used and there will be an 8 digit code that will be needed to program remote.
Open drivers door enter vehicle and close drivers door.
Within 15 seconds turn key to the ON position and back to LOCK 10 times. An acoustic signal is emitted once to indicate programming mode has been activated. Another continuous acoustic signal will follow and interior lamp will flash until programming is complete.
Note: If an error occurs during programming, the acoustic signal will stop, the interior lamp will go out and the programming will need to be started again.
Within 45 seconds:Open and close driver's door. An acoustic signal is emitted until the ID number is entered.
Press the LOCK button on the door panel the same number of times as the first digit on the remote ID code.
When the digit has been entered press the UNLOCK button on the door panel.
Repeat procedure with each digit in the remote ID code counting from left to right.
Repeat programming procedure for the entire ID number a second time.
An acoustic signal is emitted once to indicate programming complete.
Repeat ID number entering procedure for any additional remotes to be programmed and test remotes.
msrp 160.31