Long unavailable, the 2 pin speaker connector plugs were once used in virtually every record player, radiogram and tape deck from the early 60s till the 1980s
Our new plug replaces the old style plug and as an added bonus we've designed it so that the pins can be loaded from the side pre-soldered without any special tool, so if you have a broken plug just remove the pins and push them into our new plug
Unique/enhanced features of the new plug:
1) made of insulating TPU material (like rubber)
2) are shaped to help you pull them out with minimum of stress on the wires
3) pins can be pre-soldered then loaded from the side
4) 2 separate compartments insulate each wire from the other wires
5) flexible, so easy to insert with minor alignment variations easily overcome
6) virtually unbreakable
7) no special tool/riveter required, simply push the pins in via the side slots
8) reusable, simply unload the pins and use it again elsewhere
9) makes feeding wires through holes much easier, simply unload the pins, feed the wire and pin through small holes then reassemble the plug on the other side!
Comes with 2 pins, a 2.1mm and a fatter 3mm pin approx 9mm apart centre-to-centre (note: all measurements +/- 0.2mm) just like the original. The pins are not new but they are clean, straight and ready to solder and install. Photographic instructions and tips also provided