2" 52mm 2 In 1 Multifunction Gauge Fuel Level&Water Temp Gauge for Boat Car ATV
2" 52mm 2 In 1 Multifunction Gauge Fuel Level&Water Temp Gauge for Boat Car ATV
Application: Marine Boats/Truck/Bus/Motor Home/Hot Rod/Generators
About the Gauge Reading:
- The device works, with a little delay (about 20 seconds) of changes in the readings. Apparently, it is done in order not to react to the splash of water in the tank.
Feature:
- 52mm diameter Two in One Gauge show with easy installation
- Programmable Input Resistance Ohm Signal to adapt different fuel /water/temperature sensor
- 0-190Ω,0-180Ω,10-180Ω,240-33Ω,240-30Ω
- High Resolution View under sunshine
- Installation Diameter: 52mm (2inch)
- Reverse polarity protection and anti-fogging performance
- Working Voltage:12V/24V
- Working temperatures: - 40 to 85°C
- IP66 Waterproof
INSTALLATION GUIDE
- 1. Cut an Φ52mm (2-1/16") hole in the panel (II) allow a clearance of 55mm (2 3/16”). behind the panel.
- 2. Remove fastening ring (I), insert gauge from front. Tighten gauge (III) using fastening ring ( I)
- 3. Connect cables according to the diagram/label.
Setting Menu:“Unit” “R 1” “R 2”
- 1.Hold & Press the button, Power On Gauge, the LED screen will show Switch Show
Unit, R1, R2
- 2.Unit
Fuel Gauge, Water Level, HTG Sewage Level: %
Water temperature: ℃ or ℉
- 3.R1---Configure Top Row Signal Range
Press Button to switch 000 ~006
For example, LED will show 001, which means 0~180ohm, then release the button and wait digital flash to complete to save setting
Package: