Product Description
Product Size: 31 X 24.55 X 24.5cm / 12.2 X 9.64 X 9.64
Operation
1. Preparing For Operation
After checking that all the parts are intact and complete, position the machine on flat.
Fill the consumable into feed port when power off
Always connect the product to a grounded circuit. Before power on, make sure it is connected with the rated voltage.
Turn on the machine, it will immediately start heating up.
2. On-device Manual Control
To access the control panel functions, use the four buttons located underneath the LCD display.
Button | Function |
|
Switch menu pages to select a function |
|
Inceases the numeric value of current function |
|
Decreases the numeric value of current function |
|
Switch between current menu page and standby page
|
Menu Page
Control Board |
Description |
Heating/Ready To Work |
Heating Up/Finish heating up, ready to work |
DMX512 Add |
Set DMX strating address |
Volume Out 100% |
Set the Spark height |
Remote Add |
Set OFF the remote functions and set the remote address |
Manual Test |
Press Enter to trigger spark output manually |
Tip Over |
Set ON/OFF the tip over functions |
Set Heater |
Manually set ON/OFF the heater |
4. DMX Channel And Values
Channel |
Function |
1 | 0 Spark off, 1-255, Spark higher when the value bigger |
2 | 0-249 Heat-up off 250-255 Heat-up on |
5. Indicators And Updates
UPDATE | Data update button |
DMX | Lights when receiving a normal signal DMX |
READY | When the light is on, The machine is heated and ready to work |
ERROR/UPDATE | When the light is on, The device is faulty or the data is updated |
HEAT | When the light is on, The machine is heating |
UPDATE | Data update interface |
6. Wireless Controller
Button | Features |
ON | Heat-up on |
OFF | Heat-up off |
5S | Spark work 5s |
10S | Spark work 10s |
20S | Spark work 20s |
Addr1 | The remote address 1 spark |
Addr2 | The remote address 2 spark |
Addr3 | The remote address 3 spark |
High | Spark height level biggest |
Mid | Spark height level middle |
Low | Spark height level lowest |
Stop | Spark stop |
6. Fill Spark Seed
Fill the comsumable into the feed port, NOT into the output nozzle when power off.
Close the lid securely after filling.
The capacity of storage bin is 200g.
7. TECHNICAL INFORMATION
1). Precaution For Use
After use, should observe whether there are nodules in the nozzle. If yes, it needs to be clean up, otherwise it will affect the spray effect and even damage the machine.
2). Machine storage
Before storing the machine, empty the storage bin, clean it as described in the "Maintenance" section.
Remove the power cord from mains power, and allow unit tocool down. Empty the storage bin through feed port by inverting the machine.
Keep the machine in dry cool place.
Notes:We won't ship to VIRGIN ISLANDS, PUERTO RICO, ALASKA, HAWAII and GUAM for free. We need to calculate the shipping fee additionally. BUY IT, We will contact you and calculate for you.