Fuel Injector Tester Cleaner Kit & 2 Years After-Sales Service
Four-Wire Dual-Channel Design: Allows you to test each injector individually or both injectors simultaneously, helping you diagnose injector problems and quickly confirm stuck, leaked, damaged or burnt-out conditions.
8 Pulse Modes & Mode Lock: Press the "MODE SET" button to select the required pulse signal output mode. The LED screen will display the currently selected pulse mode, and the mode lock function can ensure test condition uniformity.
Reverse Polarity & Short Circuit Protection: This tool includes power input reverse polarity protection and output short circuit protection functions. In the event of a damaged injector or a short circuit at the pulse output, the power indicator light of the fuel injector cleaner will flash.
Equipped with Four Adapters
Small and Large Size Adapters: Compatible with fuel injectors on most cars and motorcycles.
Medium Size Adapter: Compatible with VW and Audi vehicles.
Adapter with Threaded Hole: Compatible with BMW N series vehicles.
Wide Compatibility:
1. The fuel injector cleaning kit works with any fuel pressure tester.
2. This fuel injector test kit can be modified for relay testing or solenoid valve testing, and other modifications should be carried out under the guidance of professionals.
8 Pulse Modes (Mode 1 - Mode 8)
Mode 0: Standby State, no output
Mode 1 (Single Pulse Low Power Mode) and Mode 5 (Single Pulse High Power Mode): the fuel injector tester will send out a pulse with a pulse width of about 255 milliseconds.
Mode 2 (Short Pulse Low Power Mode) and Mode 6 (Short Pulse High Power Mode): the fuel injector tester will send out 50 pulses with a pulse width of about 7 milliseconds.
Mode 3 (Long Pulse Low Power Mode) and Mode 7 (Long Pulse High Power Mode): the fuel injector tester will send out 100 pulses, and the pulse width is about 3.5 milliseconds.
Mode 4 (Continuous Pulse Low Power Mode) and Mode 8 (Continuous Pulse High Power Mode): the fuel injector tester will output pulses continuously, the pulse rate is about 50 pulses every 1450 milliseconds, and the pulse width is about 7 milliseconds.
NOTE: During the pulse output period, the MODE SET button is invalid, and the working mode can only be selected by pressing the PULSE button again to terminate the output.
Easy-To-Operate Fuel Injector Tester Pulse Tool
1.Turn off the car engine.
2.Remove the wire plug of the vehicle injector to be tested, then connect the red pulse output terminal of the fuel injector tester tool to the positive pole of the fuel injector, and the black pulse output terminal to the negative pole of the fuel injector.
3.Connect the red clip of the fuel injector tester cleaner to the positive terminal of the 12V car battery, and connect the black clip to the negative terminal of the battery.
4.Press the "MODE SET" key to select the desired pulse signal output mode, and the screen will display the currently selected mode.
5.After selecting the desired pulse signal output mode, press the "PULSE" key, the fuel injection cleaner will output pulses to the automotive injector to be tested, and the signal indicator will light up when the pulses are output.
6.After the test is completed, if you need to repeat the test, you can press the "PULSE" button again. If you want to change the pulse mode, you need to disconnect the battery of the fuel injector cleaner tool and then reconnect it.