Waterslide Transfers for Scaleauto/ Scalextric, Arrows A18

These are a home designed and made to measure sets of decals to transform the ScaleAuto 90-97 model into an Arrows A18 from 1997.

This is the car which was driven by Damon Hill to second place in the Hungarian GP which he should have won if it hadn't been for a hydraulic failure

Instructions for use:

• Clean the surface where the decal is to be applied. Smooth and glossy is best.
• Cut out your decal carefully, as close to the design as possible. (printed using waterproof ink) 
• Note: some decals have a colour mask around them which can be cut into.
• Place the decal in warm water for 20 secs or until it just moves on the backing paper
• Transfer to surface using tweezers and position carefully, using something like a wooden toothpick.
• Roll a cotton bud over the decal to squeeze out any water. Only do this a couple of times.
• Once dry, its recommended to apply a coat of Microscale Micro Gloss or something similar.

 Auction includes a set sheet of transfers only. The car is not included.  Thanks for Looking!