Waterslide Transfers for 1/32 Scale Slot car - ATS HS1

These are a home designed 1/32 scale set of decals for an ATS HS from 1978.  Originally designed for a DNQ resin kit, they should fit any 1/32 scale representation of the car.

 Auction includes a set sheet of transfers only. The car is not included.

Instructions for use:

• Clean the surface where the decal is to be applied. Smooth and glossy is best.
• Cut out your decal carefully, as close to the design as possible. (printed using waterproof ink) 
• Note: some decals have a colour mask around them which can be cut into.
• Place the decal in warm water for 20 secs or until it just moves on the backing paper
• Transfer to surface using tweezers and position carefully, using something like a wooden toothpick.
• Roll a cotton bud over the decal to squeeze out any water. Only do this a couple of times.
• Once dry, its recommended to apply a coat of Microscale Micro Gloss or something similar.

 Thanks for Looking!