Features:

Antenna This is used to extend the effective distance of controller Waterproof and dustproof It is made of plastic material IP 54 

Notice：

1,Terminal 1 is for connectino thepower input; working voltage is 12-265VAC/DC.

2,Terminal 2 is for connecting the antenna of RF controller to extend the effective working distance

Instruction:

After power the lamp on, LED will start fashing in 1HZ(default setting).

sW1 is the switch for selecting flashing or on mode of the lamp.CAP short connectsthe 2 pins; the lamp is in flashing mode. Remove the CAP from 2 pins, the lamp is inon mode.

Be Careful, the whole board includes the components are with high voltage. Alwaysmake sure power is off before you open the cover

Installation：

Open the package; take out the products and all the accessories. Removing the antenna by rotatinganticlockwise.

Mark 2 holes on the wall by using the fixing hole of bracket.

Drilling two 6mm diameter holes and one 10mm diameter hole. Then put the expansion plug intothe 6mm diameter holes. Put the wires through 10mm diameter hole.

Put the power wire and antenna through the cable holes in the holder. And fix the holder to thewall by provided 4mm*30mm self-taping screws.

Connect the wire and antenna to the correct terminals.

Put the cover back and make sure the cover is fastened with the bottom base without any gap.Then screw the antenna up and turn clockwise to make it tight.

Always install the holder and lamp upright to the ground. Horizontally installation may cause therain go inside the lam and damage the board.

Specification:

Working voltage: 12-265V AC/DC

Loading capacity: 1.5W

Weight: 156g

Flashing frequency: 1Hz

Installation method: Vertical/horizontal

Working temperature: -20°C~+60°C

Protection level: IP54

Size: 60*85mm

Package Contents:

1*  Light

Note:
1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2. Please allow slight manual measurement deviation for the data.

We accept payment via Paypal only.

Payment must be completed within 5 days. If you have any problems about payment, please contact us via ebay message.

We only ship to confirmed Paypal addresses. Please comfirm that your paypal address is in line with your shipping address.

Please kindly note that the combined shipping is not provided because the shipping fee is calculated by weight. Also, the each additional item means exactly the the same color and size. 

It takes about 7-15 working days to UK; about 10-30 working days to other countries. Transit time may be a little delayed because of the bad weather and customs inspection. If you do not receive your item within 30 working days since payment finished, please contact us immediately for further assistance.

We strive for 100% customer satisfaction! Positive Feedback is very important to us. If you have any questions, please feel free to contact us via "Ask seller a question" . We will reply your email within 24 working hours.