• Decal measures Approx. 48"w x 9.5"h. (set of two pieces)
• Cut using professional wrap film.
• Matte finish
• Fits Tacoma 2016 & Newer
Premium wrap vinyl best quality and durability not to mention the ease of installation. Air release technology will allow air to escape providing an installation without bubbles. Beware of other films available online, which will NOT last as long and be extremely difficult to install, subject to bubbles and installation a nightmare.
Recommendations for installation:
Align the graphics on the panel. Use masking tape on both sides of the decal to hold the vinyl in place. Create a hinge down the middle of the decal with a long strip of masking tape, then Cut off 18" of the liner on either side, and squeegee vinyl to the panel applying firm pressure, remove the center hinge tape, Then slowly apply the rest of the vinyl by removing the liner as you work your way across to the other side. Use a heat gun to warm up the vinyl as needed to soften the vinyl as you squeegee vinyl into the bends and curves of the truck panel (if necessary). If you get a crease just peel back and warm up the vinyl again to smooth it out. Wrap vinyl goes back to being smooth when it is warmed up with the heat gun. Message us with any questions.
What You Need:
• Wrap Vinyl (comes cut ready to install)
• Squeegee (included)
• Heat gun (not included)
• Tape measure (to center the vinyl)