*** ATTN EBAY- THIS AUCTION CONTAINS NO FIREARMS AND NOTHING THAT CAN BE MADE INTO A FIREARM. THE AUCTION IS FOR THE WOOD GRIPS AND GRIP SCREW ONLY ****

This is for an nice vintage set of factory wooden presentation grips for a S&W K or L frame revolver. The grips fit perfectly on a Model 10, 14, 15, 64, or even 686, etc...Any K or L frame, (as I show here). 

Sadly, these grips came from a S&W Model 19 no-dash revolver that was cut in half by a large western police department in a gun buy back. The grips were carefully removed before the frame was cut in half. These grips were ordered from Smith and Wesson on the gun extra from the gun itself. Grip screw is included. The figure on these grips is wonderful and typical of old school Smith and Wesson quality. They were very lightly refinished with urethane but they look very presentable for upscale shooter grips. The figure on these walnut stocks is really stunning. I think they look great on a stainless gun and even better on a blued K or L frame. No date that I see on the grips, but it has the nickel rear washer, so I'm sure it was probably early 1970's or so? I am not sure if they are rosewood or some type of fancy walnut that was used in their manufacture? Look and make your own decisions. They really feel good in your hand on this four inch Combat Masterpiece model 15-3 shown as their model. The fit nice and tight and really set a K frame off from the others.

Why buy Thailand grips made from a vine when you can get original factory, unnumbered grips for your gun?

Shipping is a flat $5 for anywhere in the continental US and if it is more than that, I will pay the difference. I despise shipping gougers on Ebay that always ask the moon for shipping. 

Price is $155 as shown. Email any questions.