300w Melt Tin 1.4KG Temperature Adjustable Melting Tin Furnace Solder Stove Lead-free Solder Pot CM-558 Digital Square Tin Stove

CM series tin furnace operation method and function.
1. Performance characteristics:
1. The CM series lead-free tin furnace is equipped with a high-power heating element, which can quickly dissolve the lead-free tin bar from room temperature to 450°C, and it only takes about 25 minutes (specifically, there will be slight differences depending on the size of the tin furnace).
2. Using microcomputer chip intelligent control, dual digital display, intuitive and clear, high thermal sensitivity, rapid temperature recovery, and quick temperature compensation.
3. The lead-free tin pot is made of imported titanium material, which is resistant to high temperature, corrosion, abrasion and durability.
4. The setting data of the tin furnace is directly input by touch keys, which is simple and accurate.
5. The data set by the machine can be stored for a long time without being affected by shutdown or power failure.

2. Working environment:
1. Working voltage: AC220 soil 10V (1 10V can be customized)
2. Working temperature: 0-55 degrees
3. Working temperature: <90%RH without condensation

3. Operation method and function setting:
1. Temperature setting:
(1) Turn on the power switch of the tin furnace, the operation panel will display the temperature measurement value 3.0.0 and the temperature setting value 2.8.0.0., directly use the plus + or minus-keys to adjust the temperature setting, and press the plus + or minus-keys. It will rise or fall by one unit. Long press the plus + or minus-keys to continuously rise or fall. The set temperature will be automatically stored for a long time after two seconds after setting, and will not be affected by power on or off.
(2) Turn on the power of the tin furnace, the operation panel will display the temperature measurement value 3.0.0 and the temperature setting value 2.8.0.0., use the shift key type * to adjust the temperature setting value. Use the plus + or minus-keys to adjust this number. The set temperature value is automatically stored for a long time after two seconds after setting, and is not affected by power on or off.
2. Microcomputer self-tuning:
If the deviation between the temperature measurement value and the temperature setting value is too high (3-5 degrees), or when the deviation between the temperature measurement value and the actual furnace temperature is too high (10-20 degrees). Please carry out the auto-tuning operation, press the shift key * and hold for three seconds, the thermostat will automatically enter the auto-tuning state, display AT and the set temperature, and the two subtitles will flash intersectingly, directly for 20 minutes to 40 minutes At the end of auto-tuning, the temperature value you set will be displayed normally. When the auto-tuning is not over, if you want to exit, press and hold the shift key * again until the flashing stops.

4.square high temperature lead-free tin furnace
●Suitable for various wire and circuit board soldering operations.
●Dual digital display, room temperature -600 degrees can be set at will.
●The lead-free tin pot is welded with imported pure titanium plate, and after high temperature anticorrosion treatment, it has better temperature resistance and anticorrosion performance.
●The temperature control part adopts intelligent microcomputer PID chip, with one-key auto-tuning and saving function, phase shift trigger control, stable temperature.
●High-quality energy-saving infrared heating element,
It can work in a high temperature environment of 600 degrees for a long time.

Troubleshooting
1. When the machine is powered on, check whether the fuse is open or whether the plug is properly inserted.
2. The temperature is unchanged when the machine is turned on, and the heating element is disconnected if the heating element is not heated.
3. If the temperature is high on the left and HIA or ORA is displayed on the right and flashing after starting up, it means that the thermocouple is open or the temperature control meter is malfunctioning.