The Lowrance Replacement holder to re-mount transducer for Tripleshot or hook2 reveal models with the extra long skinny transducers. broke off the stainless steel bracket, I tried glueing mine a few times but kept braking, didn't have enough surface area. This transducer holder fits into the original stainless steel mount. It's a perfect and easiest solution for securing your broken transducer to the boat mount. Made from durable plastic, it comes in black that complements the Lowrance brackets that would normally hold the original transducer prior to it being broken.

This transducer mount is specifically designed for Hook2 or similar Tripleshot models with the same long type of transducers, ensuring a perfect fit. This mount provides accurate underwater readings for your fishing needs and its made in Australia for faster delivery.

This Lowrance Replacement holder mount is an essential accessory to avoid having to replace the whole tranducer when broken, which otherwise would effectively make it beyond economical repair, at the cost of over $200.

Replacement holder mount is compatible to transducers with Lowrance 7, Hook2 Triple-shot or similar models. If still unsure, please ask. Does not include stainless steel bracket or transducer, just the plastic holder.

- Instructions -

First, remove the broken part of the holder mount from the transducer, a straightforward process using a hack saw. Just cut it starting from the inside of the mount, using the top of the transducer as a guide. It's essential to be cautious not to damage the wires or the transducer itself during this step.

Then slide on this new holder and secure the top angle adjustment part of the holder into the original stainless steel bracket. The transducer fits snugly into the new mount and on transducer, as an added option, you can secure it further with a 5mm grub set screw, 12mm in length, through the hole at the top of the mount, although not always required.

Tested at boat speeds up to approximately 40 kilometres per hour.