Steering kit Steering Adapter for Jeep (CJ, YJ, TJ & XJ)
Steering kit Steering Adapter for Jeep (CJ, YJ, TJ & XJ) Features: This
procuct is for the Jeep Y link steering and is designed around the Jeep
tie rod end. Use on any other steering kit is at your discretion. Fitment: For TJ Wrangler, Rubicon and Unlimited 1997 to 2006 For XJ Cherokee 1984 to 2001 For MJ Comanche 1986 to 1992 For YJ Wrangler 1987 to 1996 For Jeep Grand Cherokee ZJ 1993 to 1998 Not for use on tie rod ends at the knuckle or pitman arm. Installation Instructions: *When installing this product, be sure to verify that the pin on your tie rod end seats completely in the taper. *To
verify your pin is seated in the taper, apply a marking compound (like
gear marking compound, grease, lipstick, etc.) to the pin and tighten
down the tie rod end then remove it again. Check the pin and taper to
see if the marking compound is spread thinly and evenly around the pin.
If it does not spread evenly, the pin is likely not seated completely.
Sand down the face of The Cure for Jeep until the pin seats fully.