Ubiquiti UA-G2 Access Reader G2.


Features

  • Unlock using an NFC card or UniFi Identity mobile app
  • Additional handwave unlock functionality
  • Entry and exit greeting messages
  • Connects to UniFi Access Hub using PoE
  • IP55 weather resistance (-30 to 45° C)

Technical Description

  • Mechanical
    • Dimensions: 93 x 40 x 36.5 mm (3.7 x 1.6 x 1.4')
    • Weight: 82 g (2.9 oz)
    • Enclosure material: Polycarbonate, glass
    • Mounting: In wall, gang box
    • Weatherproofing: IP55
  • Hardware
    • Networking interface: (1) 10/100 MbE RJ45 port
    • Connectivity: BLE 4.1
    • Power method: 
      • PoE
      • UL 294 Power-limited Class 2 PSU
      • UL 60950-1/62368-1 LPS/PS2 PSU
    • Supported voltage range: 48V DC
    • Max. power consumption: 5W
    • ESD/EMP protection: Air: ±15kV, contact: ±8kV
    • Sensors: Proximity sensor
    • Speaker: (1) 8 ohm, 0.7W
    • LEDs: R/G/B/W
    • Button: (1) Factory-reset
    • NFC frequency: 13.56 MHz
    • NFC read range: < 30 mm
    • NFC standards: ISO 14443A, 14443B, 15693
    • NFC technology: 
      • NFC Tag 1,2,3,4,5
      • MIFARE Classic
      • MIFAREPlus
      • MIFARE Ultralight
      • MIFARE DESFire
    • Operating environment: Outdoor use
    • Ambient operating temperature: -30 to 45° C (-22 to 113° F)
    • Ambient operating humidity: 5 to 90% noncondensing
    • Software information: The software version of a product can be checked at https://unifi.ui.com
    • UL 294 level: 
      • Destructive attack: Level I
      • Line security: Level I
      • Endurance: Level I
      • Standby power: Level I
    • UL 294 statement: 
      • Compliance with IEEE 802.3 specifications was not verified as part of UL 294.
      • The equipment is intended to comply with the section of the National Electrical Code, ANSI/NFPA 70, Article 725.121, Power Sources for Class 2 and Class 3 Circuits.
    • PoE cabling requirements: 
      • Cable 5e cabling is the minimum performance category recommended. The performance category utilized should match the transmission speed required at the installation site.
      • The minimal conductor gauge permitted to connect between the PSE or power injector and the PD shall be 26 AWG (0.13 mm2) for patch cords; 24 AWG (0.21mm2) for horizontal or riser cable.
    • CAN/ULC-60839-11-1 Grade: Grade assignment: I
    • Certifications: CE, FCC, IC, UL 294, CAN/ULC-60839-11-1
    • Document number, and issue date and/or revision level: UA-G2/UA-G2-Black, V02
  • LED
    • System:
      • Steady blue: Adopted/device is ready
      • Steady white: Pending adoption
      • Blinking white/blue: Upgrading firmware
      • Strobing red: Emergency lockdown
  • Software
    • Management application: UniFi Access: Version 1.5.9 and later