This is in very good condition. Clean clear optics with a small amount of typical dust. There is one flaw ( it looks like an abrasion) on the coating of the front element, it's visible in photo #3 at about 10 o' clock. There is no noticeable impact on image quality. I'm including a 3D printed lens board. It a Sinar board slightly tapered at the top to allow use on an Intrepid 8x10. ( Note it only covers at close subject distances and with no movements)

Also included are the lens caps pictured

* I added 2 photos made with this lens on my 8X10 camera. The 1st one cropped a little because I used too much rise and got vignetting. The second one is a basically straight ( only resized to fit here and slight contrast adjustments) scan of a full 8X10 negative shot with no movements, so covers fairly well then with slight vignetting at the corners