5 Meter LED Auto Car Interior Accessories Decoration Atmosphere Wire Strip Light Lamp

Specification：

Condition: 100% Brand New

Material: Plastic

Color: White, Red, Orange, Yellow, Green, Fluorescent Green, Blue, Ice Blue, Purple, Pink

Voltage: 12 V DC

Size(L*W): 500cm * 0.6cm

LED Type: Cold LED Light Strip

Fitment Type: Direct Replacement

Placement on Vehicle: Internal

Connection: Direct inserted in cigarette lighter. 

Installation: With 6mm broadside, you need to install the broadside into the gap of car interior trim panel.

Fitment:

Suitable for atmosphere light, accessory light

Almost fit for all car models. It can be used for RVs, campers, trailers, cars, trucks, SUVs, ATVs, boats, etc. 

Before purchasing, please kindly check our item description, photos and size are consistent with your needs, so as to avoid discomfort in subsequent installation.

Features:

1. Easy to install: Plug and play. Cut off the excess part according to your own suitable length, then seal the cable end.

2. Flexible wire: LED rope light is 5 meter long; flexible and water resistant.

3. Multiple uses: Good for parties festive decoration, camping bar, DIY and so on.

4. Durable: Low-power electrode wire practical and safe, waterproof, no radiation, lifespan up to 10000 hours.

5. Energy-saving: High brightness and less power consumption, not glaring and very fashionable.

6. The elimination of the strobe light-emitting more stable. It will help improve visual resolution, improve efficacy; reduce visual fatigue of continuous operation, help protect eyesight.

7. More suitable for automotive use, flat round, the greater the force, not easy to fall off

8. Special quasi-cold light emitting principle and power consumption is small, so only specific power drive to run properly!

Package Includes:

1 x 5 Meter Cold Light Strip

1 x Cigarette Lighter Adapter

Instructions for Use:

1. Cold light must be connected with the drive to use, and can not be connected directly to the power supply.

2. Cold light can use double-sided tape or glue fixed and then the car.

3. Cold light can cut use, cut the part can be discarded, ownership length does not affect the use of the remaining part of the.

4. Cold light requires the player Little headlight alignment.

Installation Steps:

1. Determine the location in the car where you want to install it.

2. Measure the length of the part to be installed, then cut the same length on the light strip.

3. Install the light strip in the location where it needs to be installed (need to use the tool to pry open the slit in the location to be installed).

4. Connected the light strips installed in step 4.

5. Other locations in the car that need to be installed just repeat the above steps.

6. Place the wires and LED lights in the appropriate location (can be hidden in the center console, under the footrest or other places).

7. Connect the cig lighter to the controller, power up.

If the optical fiber and transparent tube are installed at sharp corners, please minimize the abrasion of the optical fiber.

If the length of a section of optical fiber used during installation is long, it is recommended to install a light strip at each end of the fiber to increase the brightness.

Notes:

1. No installation instruction included, professional installation is highly recommended.

2. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.

3. All dimensions are measured by hand, there may be small deviations.

4. If you buy it and cut it by yourself, you must do a good job in insulation treatment, and do not touch the positive and negative poles after the end is cut, resulting in short circuit. Once cut by themselves after the store is no longer responsible for any after-sales issues.