In Good condition - Powers up but no further testing was done. This is old so being sold for parts or repair since it's working condition and how it works is unknown to me, sold as pictured.
PROBABLY WORKING FINE.
Probably working fine.
| GENERAL | |||||||||
| Type: | Amateur HF transceiver | ||||||||
| Frequency range: | TX: 10-160 m RX: 10-160 m and WWV/JJY (10-10.5 MHz) The AUX position provides one optional 500 KHz band segment except between 2.0-3.5 and 5.5-7.0 MHz. | ||||||||
| Tuning steps: | Analog / continuous | ||||||||
| Frequency stability: | Less than 100 Hz drift in any 30 minute period | ||||||||
| Mode: | AM / SSB / CW | ||||||||
| Channels / memory management: | 2 optional XTAL controlled | ||||||||
| Repeater shift / offset: | No | ||||||||
| Power supply: | Mains: 100 / 110 / 117 / 200 / 220 / 234 VAC or 11-14 VDC A twelve-prong Amphenol/Cinch-Jones connector has to be wired for either mains or DC voltage | ||||||||
| Current drain / power consumption: | RX: 45 W @ mains - 600 mA @ 12 VDC TX: Max 350 W @ mains - Max 21 A @ 12 VDC | ||||||||
| Antenna impedance / connector: | 50-75 ohm / SO-239 | ||||||||
| Dimensions (W*H*D): | 334*148*284 mm (13.15*5.83*11.18") | ||||||||
| Weight: | 13.6 Kg (29.98 lb) | ||||||||
| Other features: | NB. VOX. XTAL-calibrator (25 & 100 KHz). 3.18 MHz IF output. | ||||||||
| RECEIVER SECTION | |||||||||
| Receiver system: | Double conversion superheterodyne 1st IF: 5.52-6.02 MHz 2nd IF: 3.18 MHz | ||||||||
| Sensitivity: | 0.3 uV (10 dB S/N) | ||||||||
| Selectivity: | AM/SSB/CW 2.4 KHz (-6 dB) 4 KHz (-60 dB) CW (With optional narrow filter) 600 Hz (-6 dB) 1.2 KHz (-60 dB) | ||||||||
| Image rejection: | |||||||||
| AF output power / speaker: | 3 W at ?% distortion / ? ohm | ||||||||
| External speaker connector: | 4 ohm | ||||||||
| TRANSMITTER SECTION | |||||||||
| RF output power: |
NB! Output power is slightly lower on 10 m | ||||||||
| Modulation system: | |||||||||
| Max FM deviation (Factory set): | No FM | ||||||||
| Spurious emissions: | Better than -40 dB | ||||||||
| Microphone impedance / connector: | ? ohm / 4-pin (Metal locking ring connector) | ||||||||
| Microphone input level: | ? mV | ||||||||
| MISCELLANEOUS | |||||||||
| Manufactured: | Japan, 1975-197x (Discontinued) | ||||||||
| Additional info: | Hybrid transceiver with a 12BY7A driver and two 6JS6C finals | ||||||||
| Related documents: | User manual (10.9 MB) Service manual (15.7 MB) | ||||||||
| Modifications and fixes: | |||||||||
| Reviews: |