Davis Leveling fixture and 3rd axis leveling block ( Sight not included, for instructions only)

Mounts to bench with screws or clamp
Comes with single knob Davis dovetail mount, which
can be removed and use your own mount block.
Adjust leveling fixture, with nylon tipped setscrews till bubble is in middle

Mount sight into fixture.
Attach the 3rd axis leveling block, it is made to mount to the two guide rods on Davis sights
Then simply loosen frame screws and move till bubble in 3rd axis level is in middle
Tighten bolts, double check, that bubble is good
Then loosen screws on scope adapter block ( block where scope mount to, with two dowel pins sticking out of)
just leave tight enough, where you will still be able to move.
Get bubble in middle, then tighten screws in adapter block, double check, that is still in place, sometimes it takes a few tries.

At this point both bubbles should be in middle.
Then to set 3rd axis,loosen the knob on leveling fixture, and pivot the sight up about 30 degrees
watch the bubble in scope, if it moves to side, you will need to adjust.

There are two setscrews on side of scope aperture block, loosen one and tighten other
to make arm with scope in pivot. Adjust til bubble is in middle
The pivot sight back down level and see if bubble is still in middle if not, you will need to
readjust, then pivot sight to 30 degrees and double check bubble
Sometimes it takes a few tries to get set.
Just make sure you have both setscrews tight when done.