Variable Capillary Thermostat Control Switch 

Allows you set the temperature you wish the cooling fan to operate

The Fan will kick in at the selected temperature and then switch of when the engine temperature goes back down

Suitable for use with any after-market Cooling Fan

To fit in the hose simply remove the top radiator and fully insert the probe, then re fit hose and tighten over the capillary wire being extra careful not to damage the probe inside. Silicone sealant can be used to help seal if required.

Wiring Instructions

C Terminal = 12v Feed

No2 Terminal= Power out to the fan
(the switch is earthed through the fan)

No1 Terminal= Leave blank, this is not required for this application

You can also wire a relay in if you wish, but this is not a requirement.