THIS WILL FIT THE FOLLOWING:

2004-2006 G35X Sedan (AWD only)  RWD G35 version is seperate listing

 Mounting Hardware is Included!

This version of TBW Aluminum Splash Shield is for the 2004-2006 Infiniti G35X. It will only fit the AWD model for these years. It replaces the stock under tray which is made of plastic. This offers much more support to the bumper, protection for the bottom of the engine, and easy-to-change oil door for your Infiniti G35X. Additionally, having a design in 3 separate pieces make it much easier to work on the engine because you will normally only need to remove the rear section.

Protecting your engine is very important, and the OEM splash shield doesn't do much. This aluminum engine shield is a direct fit for the Nissan 350Z and Infiniti G35. Not only will it protect better than the plastic splash guard, it will strengthen your bumper and make your vehicle easier to work on. Imagine not having to take the entire under tray off each time you change your oil! The built in oil trap door on this aluminum splash shield will make changing the oil a quick and clean process for your G35 or 350Z. Sleek, stylish, keeping the engine clean and offering much better protection, all while weighing only a single pound over the stock plastic under tray. Don't hesitate to put this on your car, as it will be one of the best value purchases you can make for your G or Z. Protect your VQ with only the best. Made from high quality aluminum, all holes are laser cut to direct fit in the stock location. This version is designed to accomodate larger oil pans, spacers, and some lower front tie braces. Installation is quick and requires little working knowledge. Most people can do it on there own with a floor jack, jack stands, and a 10mm wrench in about 15 minutes!

* Made of .063 Aluminum - only slightly heavier than stock (by ~ 1 lb) but much stronger

* Laser Cut - hole locations are fit to match stock location

* Increased Strength - Better protection for engine AND support for bumper for high speed stability

* 3 piece design - Won't bend the whole thing if you hit a curb, and can replace only the front piece. (email if needed)

* OIL DOOR - The OEM shroud offers little access to the filter. This built in oil door is accessible by removing 2 simple bolts and will keep air flow through the engine all the way back to the firewall.

 *POWDER COATED ALUMINUM (BLACK)

*MADE IN THE U.S.A