two-part Conductive Tab Repair Epoxy if an existing bed of solder is not on the glass, to bond the tabs onto the glass forming an electrical and
structural connection; Grid Repair for scratched or broken defroster lines; This handy kit pays for itself.
NOTE:
There are many YouTube videos that will visually guide you through this process.
WINDOW PREPARATION:
The tabs located along the sides of the defroster connect the defroster electrically to the vehicles defrost circuit. One tab is the positive and the other ground.
If a tab comes off the defroster this will mean total instantaneous failure of the defroster.
1. Our kit is an epoxy adhesive. To use, carefully clean and dry all surfaces to be bonded from all dirt, dust, debris and hand-prints from the rear window.
2. Apply the completely mixed adhesive kit to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong,
reliable bonds; however, maintain contact with a tape or similar for 24 Hours until the adhesive is completely cured. Please, wait 24 Hours
before using the defroster.
3. Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container
be thoroughly mixed prior to use.
4. Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52°C for 30 minutes
prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to
use for best results.
See instruction for contained easy mixing.