SUBJECT OF AUCTION |
This Auction is for SET OF 3 (three pieces) HIGHEST QUALITY 100% GUARANTEE! 19mm diameter 3mm thick Molybdenum mirror for CO2 laser engravers/cutters. Fits 40W to 150W cutters engravers. If you need any other sizes or quantities please let us know we can make one for you. Buyer to exercise due diligence to assure fit and size. Please check the size of your existing mirror to be sure 19mm mirror will fit your laser engraver/cutter |
ITEM CONDITION |
NEW |
PACKAGE CONTENT |
Here is what you will get:
|
SHIPPING & SELLER/BUYER PROTECTION |
Shipping
Seller/Buyer Protection
ATTENTION INTERNATIONAL Buyers
|
RETURNS |
Returns
|
BESIDES THIS MIRRORS ALSO WE OFFER CONVERSION SERVICES FOR YOUR CAMERAS |
Different types of conversion we generally offer
Here you can see transmission curve of the Full Spectrum conversion filter we use. As you can see it has practically 99%+ transmission in visible part of the spectrum! Below you can see transmission curves of original Canon EOS T3, T3i, T4 camera IR Cut filters. There are two filters in these camera assemblies. We called front one the one which faces to the lens and rear filter is the one faces to the sensor. To make Astronomic conversion of your Canon camera we can remove Rear filter only so:
For Infrared conversion we will remove IR Cut filter and replace it with Infrared filter. On this chart you can see that original Sony UV/IR Cut window was replaced with Neimart Dual side multilayer anti-reflective coated borosilicate clear pass window has been installed instead of replaced IV/IR Cut window |
OTHER ITEMS WE SELL |
We Ofer:
|
DISCLAIMER |
The fact of purchase constitute complete agreement and acknowledgement of rules outlined below. Should you disagree with any of this points you MUST refrain from purchase.
|