1 Metre of 3.2mm EL WIRE

This listing is for 1 metre of high brightness (3.2mm) Electro-Luminescent glow wire.

The 3.2mm is favoured by users as it is robust and its thickness offers protection while still being bright. When placed on a costume or other project it keeps straight lines without showing kinks

It is available in any of these colours:

Light Blue (Tron Blue), Lime Green, Pink, Red, Orange, Purple, Yellow, Deep Blue, Grass Green, Turquoise (being discontinued) and White

And we also have it in the following lengths: 

       50cm / 3 metre / 5 metre / 10 metre / 25 metre / 50 metre

Important: This listing is for just the EL Wire alone (with easy-click connector)

We have a large selection of drivers allowing you to choose from battery, USB or mains powered to sound activated, sequencers...... and many more!

Unless you already have an EL Wire Driver, please select the EL Driver that is most suitable for your purpose from the 'Drivers/Inverters' category in our ebay store

Because the EL naturally glows Blue/Green the brightest colour of the wire is the Light Blue, Lime Green and White. The least bright are the Red and Purple as they have to be filtered the most to get the colours right.

A wide selection of EL Tapes, EL Panels, EL Wire, Sequencers, Drivers and helpful EL accessories are available from our ebay store

This wire comes with a standard connector already attached so simply plugs into any EL Driver - this makes it easy to change between coloured wire on one Driver.

By using Splitters you can also connect different strands to the same Driver

EL Wire has loads of uses. It looks amazing when decorating the interior or exterior of cars, can be used inside and outside of the home and office and can even be threaded into clothes and hats.

This wire can be cut into smaller lengths and attached to another Driver.

Our Drivers can run many strips of wire as long as the total length of the wire is under the Driver's maximum capacity.

With some care, the EL Wire can be attached to speaker wire to make patterns or extend the wire over gaps where it isn't needed.

Joining Copper Tape and Heatshrink Tubing for attaching EL Wire is available from our shop if you want to cut the EL Wire and rejoin it or perhaps attach some wire to a different Driver.

Cutting the wire into the length you choose is simple... but rejoining it takes care and attention.

You will definitely need some wire strippers.

It is also recommended placing this joint away from where it is likely to encounter stress (e.g. if it is threaded into clothes that will then be bent and jostled - try to keep this joint out for harms way - e.g. avoid putting it at the elbows and knees.

It is a cliché to say you are only limited by your imagination but with EL Wire it is true.

If you have not seen it before it is like a really long glow stick that lasts over 5,000 hours.

We're sure you will be amazed - feel free to message us with any questions you may have.

SEE OUR SHOP FOR THE RANGE OF INVERTER/DRIVERS, SPLITTERS AND OTHER EL WIRE