Iron Man EL Panel Set

With this set you get:

2 pieces of 3cm x 5cm EL Panels for the Iron Man eyes in a choice of colours.

A Triangular EL Panel for the Arc Reactor, 18cm on long side, 12cm on short sides and 9cm at deepest point.

2xAA Driver to power the EL Panels, with continuous 'on' and Flash and Strobe modes.

2 pcs 2 Way Splitters help the panels fit onto the costume

plug and play!

The suggested setup is:

The Driver is held on the body near the chest.

One 2 Way Splitter comes out and one channel goes off to the triangular EL Panel acting as the Arc Reactor near the chest.

The other channel has a second 2 Way Splitter going off to the helmet to power the 3cm x 5cm EL Panels for the eyes.

These EL Panels are NOT See-through so you must design the eye piece to be above or below the actual eye.

By having it on a second 2 Way Splitter it makes it easier to unplug and remove the helmet - if it all runs off a 3 Way Splitter, which it could, it would not be so easy to unplug the head mask.

The kit does not include the mask or and its best to put a design over the glowing Arc Reactor - apart from that, the whole kit is ready to use -

 Just plug and play!

A wide selection of other EL Panels, EL Tapes, EL Wire, Sequencers, Drivers and helpful EL accessories are available from our ebay store

Please message a member of our team if you need any help putting your costume together or you would like more information.