Adjustable Sequencer EL Set
This is really an EL starter set. It is versatile as you can have three different strands of EL wire to work with.
With this set you get:
6 pcs 50 cm high quality (3.2mm) Electroluminescent Wire
An Adjustable EL Sequencer
It is about the same size as a standard EL Driver for 3m of EL Wire (9cm x 3cm x 2.5cm) but it has 3 outputs which sequence in a 1-2-3-1-2-3-1-2-3... pattern.
There is a dial on the side which lets you adjust the speed of this pattern from the slowest (0.7sec) right up until the wires are strobing so fast they appear constant.
The mode button also allows the EL Wires to be on constantly if you prefer
3 pcs Mini 2 Way Splitters attached to each channel allows six of these 50cm EL Wires to be lit up by this EL Driver
The EL Wires can be any combination of these colours:
Light Blue (Tron Blue), Lime Green, Pink, Red, Orange, Purple, Yellow, Deep Blue, Grass Green, Turquoise (being discontinued) and White
Because the EL naturally glows Blue/gGeen the brightest colour of the wire is the Light Blue, Lime Green and White. The least bright are the Red and Purple as they have to be filtered the most to get the colours right.
To make it easier to design your outfit, here are the dimensions of the inverters and lengths of connecting wires - there is also tips on how to create your costume.
Sequencer/Driver
The Driver takes 2 x AA batteries and has a built-in voltage inverter that 'inverts' the 3 volts from the batteries up to the 100 volts needed to make the EL Wire glow
The Driver is 9cm x 3.2cm x 2cm
It has a mode button to select between: Sequencer - Continuous On - Off
It has an 8cm wire coming out of it that leads to the...
Mini Splitters
The Splitters are 20cm long in total
It is 10cm of wire which then splits into two separate strands which are all 10cm long and lead to the...
EL WIRE
There is then another 10cm from the connector until the actual glowing start of EL Wire - then there are 6 pcs 50cm of glowing wire!
The whole kit is ready to use - just plug and play!
A wide selection of other EL Tape, EL Wire, Sequencers, Drivers and helpful EL accessories are available from our ebay store
EL wire has loads of uses
It looks amazing when decorating the interior or exterior of cars, can be used inside and outside of the home and office and can even be threaded into clothes and hats.
This wire can be cut into smaller lengths and attached to another Driver.
Our Drivers can light up many lengths of wire as long as the total length of the wire is under the Driver's maximum capacity.
Joining copper tape and heat-shrink tubing for attaching EL Wire is available from our shop, this is if you want to cut the EL Wire and rejoin it or perhaps attach some wire to a different Driver.
Cutting the wire into the length you choose is simple... but rejoining it takes care and attention.
You will definitely need some wire-strippers.
It is also recommended placing this joint away from where it is likely to encounter stress (e.g. if it is threaded into clothes that will then be bent and jostled - try to keep this joint out for harms way - e.g. avoid putting it at the elbows and knees)
It is a cliché to say you are only limited by your imagination but with EL Wire it is true.
If you have not seen it before it is like a really long glow stick that lasts over 5,000 hours.
We're sure you will be amazed - please message us with any questions you may have.
VISIT THE SHOP TO SEE OUR RANGE OF INVERTER/DRIVERS, SPLITTERS AND OTHER EL WIRE