Bring your 2005 Lexus IS300 out of the dark ages and back into the modern era!
Please Note: This key is 1.5 Inches in length. Please measure your current key blade to make sure it is the same length. If your key blade is longer you will require a different key fob.
Key fob, car remote, clicker thingy, key bob… We've heard it called just about everything under the sun. No matter what you call it, one thing is certain: life is just a little bit sweeter when you can lock and unlock your car with the push of a button. Let's face it, it's the 21st Century and no one has time to fumble with caveman technology trying to stick a key into a lock to get into their car. Once you receive your new key fob simply program it to your vehicle and you'll be sliding in and out of your car with ease just like the rest of the cool kids.
These instructions are for the Remote portion only. Using these programming instructions will not allow your key to start your vehicle only Lock, Unlock, and open trunk.
Key portion must be cut and programmed by a professional locksmith or the dealership.
Obtain all remote transmitters for this vehicle.
1. Start with key out of the ignition, open and unlock driver’s door and be sure all other doors and trunk are closed.
2. Insert key into ignition (Do not turn) and pull it out.
3. Perform these steps within 40 seconds.
A. Using the power door lock rocker switch on driver’s door perform 5 lock/unlock cycles starting with lock. Use an even pace and try to go about one cycle per second. (1 cycle = 1 lock and 1 unlock.).
4. Close, then open driver’s door.
5. Perform these steps within 40 seconds.
A. Using the power door lock rocker switch on driver’s door perform 5 lock/unlock cycles starting with lock. Use an even pace and try to go about one cycle per second. (1 cycle = 1 lock and 1 unlock.)
B. Insert the key in the ignition cylinder.
C. Turn the ignition to ON (Just shy of starting car, Do NOT Start) then back to OFF.
D. Turn the ignition to ON (Just shy of starting car, Do NOT Start) then back to OFF.
E. Remove the key from the ignition.
6. Within 3 seconds the power door locks should cycle automatically indicating
successful entry into programming mode. Return to step 1 if the locks do not
cycle at this point, if they do cycle then continue to step 7.
7. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
B. Immediately after letting go of the lock and unlock buttons, Press the lock button by itself and hold for 2 seconds. Within 3 seconds the door locks should cycle once indicating successful programming. If the door locks don't cycle or cycle twice, repeat steps A and B, your remote has not been accepted.
C. Repeat steps A and B in step 7 for each new transmitter.
8. Close driver’s door.
9. Test all remotes.