~ Will Ship Worldwide! ~

BajaRon's Custom Performance Ignition Wire Set w/NGK Iridium IX Spark Plugs

Replaced OEM Ignition Wire Part # 707000518

MSD's Low Resistance, Super Conductor Ignition Wire coupled with the NGK Iridium IX Spark Plugs will give you the Best Possible Ignition System Available for your Can-Am, V-Twin Spyder

Includes Dielectric Grease and Thermal Paste

Everything Needed for Installation

This Is Your OEM Carbon Core Wire

BajaRon's Custom Performance Spark Plug and Ignition Wire Set

Will Fit the Following Can-Am Spyder Models and Years

2008-2012 (All Models)

2010-2012 RT (All Models)

2013 RT (All Models)

2013-2016 RS, ST (All Models)

Designed Specifically for the V-Twin Spyder Models

Will Not fit any 1330 Model Spyder

The Original BRP Ignition Wires are of Very Poor Quality - They are a Power Robbing, High Resistance Carbon Core design which tends to break down with heat and vibration. Replacing these with another set of poor quality, expensive OEM wires is not your best option.

These BajaRon Custom Performance Ignition Wire Sets last at least twice as long as the OEM wires. They have a continuous Copper Alloy Core which are not affected by heat or vibration. Not only will this Custom Performance wire set deliver a great deal more spark energy to the Spark Plug. They will not break down like a carbon core wire. 

This Custom Performance Wire Set has Thicker, (8.5mm as opposed to the 6mm OEM wires) High Quality Silicone shielding which withstands much higher temperatures than the OEM wires.

The Spark Plug and Coil Boots are also thicker and of a High Quality Silicone. These will not melt and weld to the Spark Plug like the OEM, rubber  boots do.

You will get Quicker Starts and Better Throttle Response with this Custom Performance Ignition Wire Set.

Does your Spyder take longer to start that you think it should? Does it seem to miss, hesitate or have an erratic idle? Many think that these are signs of worn out spark plugs. And though it may be time to install new spark plugs. Many find that their Spyder actually runs much worse after the new spark plugs are in. 

Why? It is very simple. The OEM wires are a bigger problem than the old spark plugs. The carbon core has fractured and spark is either weak or not able to get to the spark plug at all at times. Manipulating the spark plug wires during your spark plug install has caused even more (unseen) damage to the brittle, disintegrating internal carbon core. 

Yes, you can get carbon core wires in bright colors with much thicker shielding that look just as good (on the outside) as these MSD Helically Wound, Copper Alloy Core wires. But they will have the same power robbing, carbon core which tends to break down with heat and vibration.

With the BajaRon Custom Performance Ignition Wire Set you get it all. Much more spark energy delivered to the Spark Plugs. Longer Life. Quicker Starts. Better Throttle Response and Longer Service Times between Ignition Wire Maintenance. 

You will Receive

1- BajaRon Custom Performance Ignition Wire Set (MSD Super Conductor)

1- Packet of Dielectric Grease

1- Packet of Thermal Paste

1- Instruction Sheet