DB37 DSUB 37pin Male/Female Adapter Breakout Board Connector (D12)

Male/Female DB37 adapter / breakout board for prototyping or permanent installation.


Description
MALE / FEMALE DB37 adapter / breakout board with 37 pins plus shield connected to screw terminal blocks, allowing simple and quick connections for prototyping or permanent installation. 

This listing is for the Dual Male/ FEMALE variant - BOTH connectors have Screwlock / Jack screws fitted not Captive screws.
  • Male DB37 with Screwlock / Jack screws.
  • Female DB37 with Screwlock / Jack screws
Screwlock / Jack screws are the hex standoffs often fitted on D-SUB connectors. They are threaded for #4-40 UNC screws. They are for connecting to a cable which has thumbscrews or for mounting in a wall plate / panel which has a DB37 cut-out

Captive screws are male #4-40 UNC screws coming out of the face of the connector to accommodate direct mounting to a mating connector with jack screws.

Details
These adapter boards are used for experimentation or prototype work with parallel, serial ports, I/O cards, and any other device that uses a DB37 connector.
Complete with 4 x 3.5mm mounting holes for alternative fitting methods.

Features
  • Male & Female D37 connectors with Screwlock / Jack screws
  • Screw terminal for all 37 pins, plus shield
  • Screw terminal suitable for wire size from 0.05mm2 (30awg) to 2.0mm2 (14awg)
  • Use for prototyping or permanent installations
  • PCB dimensions : 108mm x 72mm
  • Overall height : 30mm 
  • Mounting Hole Centre Spacing : 96mm x 25mm