Treatment Zones
The 60 Second face life can tone and treat the areas of the face shown above
The
Rio 60 Second face lift can be used effectively to tone the forehead
and brow, under eye, cheeks, naso labial lines, upper and lower lip,
chin, neck and behind the ear, as shown in the Treatment Zones diagram
on the right.
The Rio 60 Second face lift can also effectively
treat forehead lines, crow’s feet naso labial lines and lines on the
chin, upper lip, neck and under eye.
How to use
Apply a
generous amount of conductive gel to each of the ball contacts, turn the
unit on then position both ball contacts on the area to be treated.
Hold the unit in position for 60 seconds to complete treatment of the
area. After 60 seconds move onto the next treatment area.
During
treatment you can increase the power and move the position of the ball
contacts if necessary until you feel definite muscles contractions. You
may need to adjust the intensity level when treating different areas of
the face. For best results follow the faradic facial toning regime every
day for the first few weeks, alternating between programmes one and two
each day.
Apply a the conductive gel to each of the ball contacts and position both ball contacts on the area to be treated
Treatment programmes
Programme one--firming
Rhythmic
muscle contractions to condition muscles with a short interval between
each pulse. Muscle contractions last two seconds followed by a three
second pause. There are 17 power levels in total. We recommend starting
on a low power level on each treatment area and build up until muscle
contractions are felt.
Programme two--tap toning
Rapid stimulating action. The pulsing massage action lasts five seconds followed by a three second pause.
Programme three--infusion
This
programme gives a continuous high frequency sensation. There are 10
power levels so start on a low level on each treatment area and build up
until a strong tingling is felt. For infusion you must remember which
ball contact is which polarity. The (+) ball contact should remain on
the patch while the (-) ball remains on the skin. Place one collagen and
retinol patch onto the area to be treated and place the other patch on
the opposite side of the face. Apply a generous amount of conductive gel
to the (-) ball contact to ensure good contact with the skin. Select
programme three (infusion) on the unit and with the (-) ball contact
touching the skin and the (+) ball remaining on the patch. Slowly and
gently move back and forth along the patch for 60 seconds and repeat the
process across the other patch. Continue treatment by alternating
between patches for 5–15 minutes on each patch. The patches can remain
on the face for up to an hour to continue gently infusing. After
removing patches, massage any residue into your skin.