3.2mm EL Wire

The 3.2mm EL Wire is favoured by crafters as it's robust and its thickness offers protection while still offering a bright neon effect. When placed on a costume or other project it keeps straight lines without showing kinks.

It is available in any of these colours:

Light Blue (Tron Blue), Lime Green, Pink, Red, Orange, Purple, Yellow, Deep Blue, Grass GreenTurquoise (being discontinued) and White

Our 3.2mm diameter wire is available in the following lengths:

50cm / 1 metre / 3 metre / 5 metre / 10 metre / 25 metre / 50 metre

Important: This listing is for just the EL Wire alone (with easy-click connector) and we have a large selection of Drivers allowing you to choose from battery, USB or mains powered to sound activated, sequencers and many more!

Unless you already have an EL Wire Driver, you must select the EL Driver that is most suitable for your purpose from the 'Drivers/Inverters' category in our ebay store

As with all electroluminescent technology, because the EL naturally glows blue/green the brightest colour of the wire is the Light Blue, Lime Green and White. The least bright are the Red and Purple as they have to be filtered the most to get the colours right.

A wide selection of other EL Tapes, EL Wire, Sequencers, Drivers and helpful EL accessories are available from our ebay store

el wire and el tape

This EL Wire comes with a standard connector already attached and so simply plugs into any EL Driver - this makes it easy to change between coloured wire on one Driver.

By using a Splitter you can also connect different strands to the same Driver.

EL Wire has loads of uses.

It looks amazing when decorating the interior or exterior of cars, can be used inside and outside of the home and office and can even be threaded into clothes and hats.

We know some of you like to tinker and this wire that can be cut into smaller lengths if you like.

Joining Copper Tape and Heatshrink Tubing for attaching EL Wire is available from our shop if you want to cut the EL Wire and rejoin it or perhaps attach some wire to a different Driver.

Cutting the wire into the length you choose is simple... but rejoining it takes care and attention.

you will definitely need some wire strippers.

It is also recommended placing this joint away from where it's likely to encounter stress (e.g. if it is threaded into clothes that will then be bent and jostled - try to keep this joint out for harms way - e.g. avoid putting it at the elbows and knees).

It is a cliché to say you are only limited by your imagination but with EL Wire it is true!

If you have not seen it before it is like a really long glow stick that lasts over 5,000 hours.

We're sure you will be amazed - feel free to message us with any questions you may have.

SEE OUR SHOP FOR THE RANGE OF INVERTER/DRIVERS, SPLITTERS AND OTHER EL WIRE