DUCATI  full fairing & screen kit for ST4S ST4 and ST2 

PLEASE READ BELOW THE DESCRIPTION RELATING TO THE SCREW HEADS

This kit contains 32 replacement  M5 & M6  rubber well nuts, button head and flange head stainless allen socket screws and nylon washers for replacing the fasteners on your DUCATI.

This kit will fit all of the Ducati ST2 ST4 & ST4S series and is a combination of the basic and the screen kits together with 2 extra screws for under the seat ( not the 'special' Ducati ones) - but as usual, please check your own bike before buying.

  These fasteners are the same high quality items that I use in all my kits.

The fasteners do not include the front mudguard fixings or the 2 countersunk screws/special washers/rubber nuts as these are impossible to replicate with the commercially available fasteners .

Please specify at the time of payment whether you want the set as pictured, or all button head or all flange head screws.

The flange head screws are shown on the left in the bottom 2 photos of the two screws.

To avoid any further confusion - for those of you who are not familiar with these screws the button heads are a standard produced item to a specified head diameter - there is no small or large headed button head in stainless that is commercially available unless you have very deep pockets.

The button head  head-diameters are  M5: 9.5mm & M6: 10.0mm.

The flange head head-diameters are M5: 11.75mm & M6: 13.5mm

If you do not specify a choice then I shall send the mixed set as pictured which is all button head except for the 4 M6 screws that are lower down on the fairing.

The details of this set have been provided by the owner of a ST4S and are believed to also be the same for the ST4 and the ST2

All the screws are A2 ( 304 ) grade stainless steel.

There has been an increase cost owing to the wellnuts doubling in price