• Condition: 100% new
• Color: Silver&Green&Yellow
• Material: Plastic & Metal
• Handle size: approx.10.3x3cm(4.1x1.2inch)(LxW)
• Sleeve size: approx.4.7x0.6cm(1.9x0.2inch)(LxID)
• Item included: 1 x Sleeve Tool
• Suitable for: 6mm anti-slip stud screw

  This Is Aftermarket Replacement Item But Not Genuine

• Note:

  1) All dimensions are measured by hand, there may be small deviations.

  2) Color may vary slightly due to the color setting of each individual monitor.

Product Dimension:

Feature:

1) Simple hand tool, to easily install and remove the Anti-Slip tire stud screws.

2) Suitable for 6 mm stud screws.

How to install the tyre studs?

1) Put the car tire studs into the sleeve tool.

2) Drill (using a very small bit) down from the center of chosen knob into the tire.

3) Drill a screw up from inside-out. If the angle isn't perpendicular to the tire, it'll stick out one side or the other.

Do one hole and screw at a time. Don't try drilling all the holes, then installing screw.

4) Put duct tape over the screws on the inside of the tire; sometimes it is best to use two layers of tape.