Iron Man EL Panel Set
Our Iron Man Sets supply you with 'plug and play' EL Panels, Driver and Splitters to help you build a glowing Iron Man Costume.
With this kit you get the following items enclosed:
1) 2 pieces of 3cm Diameter EL Panel for the Hand Repulsors.
2) Plus a 10cm diameter Round (or Triangular shaped) WHITE EL Panel for the Arc Reactor.
3) Also a 2xAA battery operated Driver/Inverter with switch to power the Panels.
4) And a specialist 3 Way Splitter and 2 x 1.2 metre Extenders to get power to the round EL Panels down on the hands.
Just plug and play!
EL Panels for the Hand Repulsor
The suggested setup is:
The Driver/Inverter is held on the body near the chest
A 3 Way Splitter comes out and one channel goes off to the round panel acting as the Arc Reactor near the chest
The other two channels are longer and these have 1.2m extender wires attached to them to run down each arm to take power to the EL Panels for the Hand Repulsor
A wide selection of other EL Tape, EL Wire, Sequencers, Drivers and helpful EL accessories are available from our ebay store
