Selling a Seadoo GTX Di WAKE GTi 4tec Jetski front storage hatch access cover 291001744
Four available from following skis
Photo 1-2 from 2002 GTX Di my ref RJ16
Photo 3-4 from job lot spares my ref R19 #176
Photo 5-6 from 2003 GTi my ref R27
Photo 7-8 from 2004 GTX WAKE my ref R45
Please do not buy
or make an offer on this item until you are certain it will fit your particular
Jetski!
THIS ITEM IS A “USED PART” SO IT
WILL HAVE THE USUAL SIGNS OF WEAR/USE ETC AND MAY HAVE MINOR MARKS OR SCRATCHES
ON IT ETC. IF YOU WANT TO KNOW A MORE DETAILED CONDITION OF A PART THEN PLEASE
ASK FIRST.
USED PARTS DO NOT COME WITH A
STANDARD WARRANTY OR 12 MONTH GUARANTEE!
Please read the
following information before making an offer or buying this item.
A lot of time is spent cleaning,
checking and listing these parts, so please take your time to study any photo’s
or descriptions carefully before purchase.
Please contact me before raising
an “Ebay case” or leaving negative feedback as I will try my best to resolve
any problems.
On most occasions you will
receive the item as shown in the photo, however on a very rare occasion, you
may be sent an identical item, but not the actual one shown in the photo.
This
may fit other similar models so either check with your dealer or research it
yourself before buying. If
you have any questions please ask before buying or bidding. Rebel Jetski’s is
one of the largest used Jetski parts stockist in the East of England for
SeaDoo, Yamaha, Kawasaki, Polaris and Mastercraft Wetjet. If you do not
see your item listed it does not mean we do not have it; so just ask or give us
a call at tel 07860 736274 and it can be listed on Ebay for you.
You
MUST make sure it is suitable for your ski before buying it or
making a best offer.
The initials
starting “RJ” or “R” in the title & description is for my stock reference
and is not a part number
POSTAGE.
Due
to courier restrictions, some larger or heavier items
posted to the area's below, may incur an additional postage charge so please
check if you want delivery to one of these areas.
AB31-AB38, AB40-AB56, IV1-IV28,
IV-30-IV32, IV36, IV40, IV52-IV54, IV63, KW1-KW14, PA21-PA38, PH4-PH41,
PH49-PH50, All BT postcodes (Northern Ireland)
HS, IV41-IV49, IV51, IV55-IV56,
KA27-KA28, KW15-KW17, PA20, PA41-PA49, PA60-PA78, PH42-PH44, ZE, IM (Isle of
Man), Channel Islands ISLE OF WIGHT - a Surcharge (in addition to any stated
postage to mainland UK).
You must
ask first for a postage price if you want delivery to a non UK mainland address
or one of the locations specified above.
I will
try to post your item as quickly as possible (usually the next working day)
after payment is received. On some occasions I will not be able to post this
quickly so you should check the standard postage times shown on the listing. No
Guarantee is given for any delays after the item has been posted and proof of
posting is always obtained.
Collection
may be possible for some larger items but you must contact me first before
purchasing the item.
ELECTRICAL ITEMS
Unless you are competent in
Jetski electronics and have properly identified the fault, I would suggest you
seek advice from an expert first and not just guess what may be wrong! You may
cause major damage to an electrical component (MPEM’s and ECU’s etc) if you
have failed to correctly diagnose what caused yours to break!
I will not issue a refund for
returned MPEM’s that have been sold as “tested and fully working” unless it has
been fitted by a certified Jetski engineer or approved repair centre. (Proof
must be supplied)
Please be aware that some
electrical parts cannot be fully tested before being posted (usually specified
in description). For this reason, please test the item on your jetski before it
is fully fitted. No responsibility or labour cost is accepted for items fitted
that are subsequently found to be faulty or broken.
During the removal of certain
parts, some electrical items may be supplied with the terminal pins removed
from the plugs. You will need to check that they are placed into the correct
terminal holes on the plug before re-fitting. Special terminal pin/plug removal
tools must be used to remove the wires from the plug for fitment. You must use
this tool, as anything else is likely to cause damage to the pins and cutting
and re soldering is an absolute NO NO!!. Some wires may have been replaced back
into the plug to prevent damage during transit so please check that they are in
the correct hole before fitting
Returns policy
As per the Consumer Protection
(Distance Selling) Regulations 2000, I offer a 14 day return and refund
service, subject to the additional terms and conditions.
1) Please
contact me first before starting a return as i should be able to sort your
problem out quicker than the standard Ebay returns process.
2) The
item I send you must be returned to me in the exact same state it was sent out
and have all the original attachments and/or internal parts. (No swapping over
of your faulty item or internals etc and trying to return item as faulty)
3) The
item must not have been dismantled or tampered with in any way, except for some
items that must be disassembled in order to fit.
4) For
faulty items, you must notify me via Ebay messages that an item is faulty
within 7 days of receiving the item.
5) A full
refund including any outbound postage will be given for faulty items or items
not as described once I have received it back and checked it.
6) Unless
the item is faulty, You are responsible for the return
post cost and proof of posting must be obtained. Items over £50 must be sent
recorded delivery or suitably insured, again at your cost
In addition to my terms you
must check that the item is compatible for your model as items
purchased in error will result in your account being blocked against any future
purchases.
Any items sold that are specified
as “spares or repair” or “faulty” cannot be returned.
Thank you
for visiting Rebel Jetski’s