SUPER STRONG SOLID AND HEAVY FLIP KEY
1. Open Driver side door
2. Put the Original key in and out of ignition 2 times
3. Close and open driver door 2 times
4. Original Key in and out once
5. Shut and open door twice
6. Close door
7. Put Original Key in the ignition and Turn ignition on
8. Turn ignition off and remove key
9. Door locks will cycle
10. Do the following for all remotes:
Press lock and unlock together for 1s, then press the lock button
11. Locks will cycle put key in ignition turn to on then off
12. Remove key from ignition, close door and test remote
Step 2 - Take key to locksmith shop and get key cut
Step 3 - Programming transponder chip
1. Put Original master key in and out of ignition 5 times. Finish with key in ignition (in, out, in, out, in, out, in, out, in)
2. Open and shut door 6 times
3. Remove original key and insert the new key (Do not turn the key, just insert it into the ignition
4. Leave for 60s (or til light goes out)
5. After 60s security light stops flashing then you can start car.
6. Take key out
7. Open and shut door
If you make a mistake at any point in the procedure, use original key to start the car.
Take the key out, open and close door. Now you are ready to start again.