TRANSFER CASE 4WD SWITCHES.  ALSO Called  4WD Transfer Switches, 4WD LIGHT SWITCHES,   Four Wheel Drive Transfer Switch, 4WD Engage Switch.

BRAND NEW OEM SUZUKI -    TWO SWITCHES - EACH SWITCH HAS IT OWN PART NUMBER, ONE HI SWITCH and ONE LO SWITCH   

    1     HI  RANGE SWITCH     4WD

    1     LO RANGE SWITCH     4WD 

   # 14 and # 16 in Basic Image

                            SELLING AS A PAIR BECAUSE IF ONE IS BAD IT CAN IMPAIR THE OTHER.

                                    (SEE PIC FOR LOCATION and BASIC REPLACEMENT INSTRUCTIONS BELOW)

SEE COMPATIBILITY CHART

IN ADDITION TO FITMENT CHART, ALSO FITS

   SUZUKI ESCUDO 1.6, 2.0 4WD  2001 - 2004

Grand Vitara XL-7   JA420WD-4

If you have an 89 - 91 with only Hi Range, contact us with your VIN #. If you have both HI & LO Range this is correct fit.

BASIC REPLACEMENT INSTRUCTIONS -   This if referencing a 2000 Tracker, Yours may vary - Reference the picture included within the ad to locate the switches

   You will be removing the console and gear select shift lever (AT) and looking down onto the top of the Transfer Case for access.

Slide seats forward, remove two side Philips screws from E-Brake console and remove e-brake console and set on driver seat or disconnect wires to fully remove.  Slide seats back, remove two plastic pins at side rear of shift console by prying out with flat screwdriver and remove two front side Philips screws. Remove shift console and unplug wiring to the N/P switch.

12 MM unbolt the shift lock release and using needle nose slide off of the bushing.  Unbolt the 4  12MM from the shift console. Remove it to expose the shift cable.  Pull the pin and slide off the shifter (Yours may vary).  

    You will now have access to the switches.  Do One at a time as they are different and take a different size wrench. Unplug the connector,  unscrew the switch and replace