"Kote-IT (K3) NANO Application Instructions"
DESCRIPTION:
Kote-iT is a Hydrophobic Genuine Nano Technology All Surface protection that is
Suitable for most types of surface materials such as Paint ,Glass, Stainless Steel ,Acrylic, Plastic, Leather, Vinyl, Fiberglass. (Concentrated water based formula)
FUNCTION:
Kote-iT when applied correctly to a correctly prepared will penetrate the surface material thus creating an extremely high resistant protection from moisture, dust and dirt thus making the surface much easier to clean.
PREPARATION:
For the best results the surface must be as clean and as smooth as possible.
For exterior surfaces such as tiles or stone pressure cleaning first is recommended.
Kote-iT can be successfully applied to both wet and dry surfaces by wipe on spraying, brushing, moping etc.
IMPORTANT:
For the very best result on motor vehicles we recommend that you very carefully clean the surface before applying .
If the surface has been washed yet still feels slightly gritty when you gently move your hand over it you should use a Clay Bar and a quick detailing lubricant like our Ultimate Detailer (or car wash in warm soapy water) to remove all surface contamination before applying Kote-iT NANO.
APPLICATION:
Motor Vehicles
A. For vehicles just washed, remove any excess water, apply a light even spray of Kote-iT onto the wet/moist surface, spread evenly with a soft moist microfiber cloth, and polish off with a microfiber-drying towel. NOTE: For the best high gloss and protection, apply 2 x even coats 2-3 hours apart.
B. For a clean dry surface, spray a small amount of Kote-IT onto a moist microfiber cloth and spread evenly, then immediately polish off with a dry microfiber cloth.
C. For windscreens and glass we recommend you only spray once a "very small" amount of Kote-iT on to a moist micro fibre cloth spread evenly and polish off immediately .
We suggest that you just add 20ml of Kote-iT concentrate to your cars windscreen washer bottle for much smoother/quieter wipers and an amazing water repellent windscreen.
D. For alloy/wire wheels, spray or wipe directly onto a just cleaned wheel, allow to sit for 5-10 minutes then wipe off any excess liquid. Your wheels will then be so much easier to clean, as brake dust will no longer stick on the surface.
2 even coats are recommended.
For further information contact BURG DESIGN MELBOURNE