This mounting plate enables you to mount your castle XLX ESC above the center diff. FITS WITH THE STOCK BODY INPLACE. It comes with a 4mm thick Aluminum plate, which mounts on four spacers (included) and is held down by four stainless steel screws (Included). The XLX esc is then held to the plate with 4 screws & nyloc nuts (All included). Once in place the sliding motor mount can still be accessed (See pic) to change the pinion.

Whilst this kit includes three extension wires as described above we also sell other extension wires - check out our 6.5mm leads here - https://www.ebay.com/itm/153524152303

And our 8mm Male to 6.5mm Female leads here - https://www.ebay.com/itm/153704988718

This kit DOES NOT come with a Castle XLX included!

To fit the kit simply remove the existing four screws in the top of the center diff, place the long screws through the countersunk holes on the Aluminum motor mount, then put the spacers over the long screws so as to mount the plate over the centre brace. Line the screws up with the holes on the centre diff cover. Tighten all four screws until plate is secure, and the plate is flush. Then mount castle esc on top of the plate using the m3 screws & nyloc nuts (Both included).