Maximum Operating Temperature 113°F (45°C)
Maximum Operating Pressure150 psig (10bar)
Maximum Feed Flow Rate 2.0 gpm (7.6 lpm)
pH Range, Continuous Operation 2–11
Maximum Feed Silt Density Index (SDI) SDI5
Stabilized salt rejection 98% (performance measured by manufacturer at 250 ppm NaCl, 77F, and 15% water recovery)
Free Chlorine Tolerance <0.1ppm
Maximum temperature for continuous operation above pH10 is 95F (35C). Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, Dow Water & Process Solutions recommends removing residual free chlorine by pretreatment prior to membrane exposure. Please refer to technical bulletin "Dechlorinating Feedwater"for more information.
Note: Actual performance will vary, based on supply water quality, contaminants, temperature, and temperature. Jett Water Systems makes no performance guarantee for Filmtec membranes, as factors affecting membrane performance and life cycle are outside our control.