DB9 DSUB 3-pin Female Adapter RS-232 Breakout Board Connector & Enclosure (D46)
Female DB9
adapter / breakout board for prototyping or permanent
installation.
Description
FEMALE DB9 adapter / breakout board with 3 pins (2,3,5) connected to spring / push-fit terminal blocks, allowing simple and quick
connections for prototyping or permanent installation.
Two
versions are available: This listing is for the FEMALE variant.
- Female DB9 with Screwlock / Jack screws for mounting
the adaptor board to a wall box or panel that has a DB9 cut-out
- Male DB9 also with Screwlock / Jack screws for mounting the adaptor board to a wall box or panel that has a DB9 cut-out - see alternative listing in my eBay shop.
Screwlock / Jack screws are the hex standoffs often
fitted on D-SUB connectors. They are threaded for #4-40 UNC screws. They are for
connecting to a cable which has thumbscrews or for mounting in a wall plate /
panel which has a DB9 cut-out
Details
The small footprint
means that the end profile of the breakout board is no wider than the connector
itself. This can be important for installations where equipment contains
multiple connectors which are spaced closely together. These adapter boards can
be mounted directly to the equipment without using extension cables.
These adapter boards are used
for experimentation or prototype work with RS-232 serial ports, I/O cards, and
any other device that uses a DB9 connector.
Features
- Complete with plastic Clamshell type Enclosure
- Female DB9 connector with Screwlocks / Jack Screws
- Spring/push-fit terminals for 3 pins : Tx,Rx,GND
- Clamp terminal suitable for wire size from 0.05mm2 (30awg) to 1.75mm2 (16awg)
- Use
for prototyping or permanent installations
- PCB
dimensions : 32mm x 31mm
- PCB height : 15mm
- Overall Dimensions : 46mm x 34mm x 21mm