Features:
Ultra-small panel size (60% smaller than traditional panels), easy to install; almost no installation depth
Easy installation-no installation depth, minimum drilling (13 x 8.5mm)
Using a compact, easy-to-access micro-usb cable, the end user can replace the cable to any desired length
Flexible wiring-control relay box is installed 1 meter away from the touch screen
IP66-strong water jet protection (only for panel)
Indicating LED / 10A self-resetting fuse for each branch
Backlight module, easy to operate in the dark, very low standby current (90% lower than previous models)
Programmable momentary buttons-all buttons can be programmed as moments (ideal for horn or wiper applications), including a set of various graphic labels and stickers
Specifications:
Product voltage: DC11-30V
Product current: 10A per branch circuit
Panel: PET film touch screen
Circuit protection: Built-in resettable fuse
Switching rating: 10A per branch
Panel rating: Maximum cumulative amplifier: 35A
Remarks: IP66 (film panel)
Power terminal: M4 stud size ring terminal
Loading terminal: 250 fast terminal
Package List:
1 x Membrane Control Panel
1 x Remote Control Box
1 x Micro USB Cable
1 x User Manual
Other Accessories as pictures show
Installation Notes:
1. Place the provided template on the desired panel position and cut the holes accordingly.
2. From the back of the dashboard, insert the micro USB plug to the front. Connect the micro USB plug to the socket on the back of the panel.
3. Install the panel firmly on the dashboard, and use self-adhesive on the back of the dashboard.
4. Install the control box correctly with the included screws.
Insert the other end of the micro USB cable into the control box. Insert the cable into the strain relief hook on the box.
5. Press the DC positive wire (+) firmly with the included round terminal. Pass the electric wire through the included insulator and connect to the screw terminal. Cover the terminals with insulators. Clamp the DC negative wire (-) with an insulated 0.250" female terminal, and insert it into the negative quick terminal on the control box.
Connect the load terminal to the required equipment. The numbers on the top of the load terminals correspond to the numbers on the membrane contact 1 2 3 panel shown on the left.
6. (Momentary button setting) Set a specific button as momentary (press), press the button and the backlight button at the same time for more than 5 seconds, until the button flashes. All buttons can be set to be short-lived. To undo this action (change the button to on-off), simply repeat the process again on the same button.