Copy link below to watch Demo Video:
https://youtu.be/1leXE4hXxbc
WATCH VIDEO ABOVE Copy and paste!
1 adapter that does it all!
This is a PETG 3d Printed Milwaukee M18 lithium
battery to 18v Ni-cad tool adapter ready for use on drill(model
0624-20), Also Milwaukee 1st V18 lithium ion drill (0824-20), flashlight(Model 49-24-0165),Impact Driver (0881-20),
sawzall(model 6514-20), circular
saw(6310-20), Rotary Hammer(5361-20) and Sawzall(6515-20). I can't guarantee that it will fit all the
Ni-cad tools, I don't own all the tools to check first. If you come
across tools that it doesn't fit please contact me so I can make a list
that it doesn't work with and/or adapt the adapter.
(LOCKS in place NO modifications to tools) Pictures show the tools I own that it fits.
Complete adapter ready to rock and roll.
There are a lot of other adapters out there. If you choose to go with another one make sure you pay attention to depth of cut on the circular saw. I have used a couple of them from China and you lose about 1/2" of the cutting pass with the 5.0 battery. Also it was very very tight to put the battery on and off.
Must remove adapter before charging Use only charger for that battery style v18 to V18 charger M18 to M18 charger. You can't charge the M18 on the V18 charger.
Not responsible for Misuse/tool or battery damage
Do not store in above 100 degrees example: hot car with sun beating down
For international buyer is responsible for any customs, duty, tariff charges.
(This does not come with batteries or tools just adapter)
Instructions:
1. Insert tool first all the way(if the tool isn't all the way in the battery will not go in all the way)
2. Insert battery it will need some pressure to push up the locking mechanism. Push until the battery locks in place.
If it is really hard to push up make sure the tool is all the way in.
Tool removal:
1. REMOVE Battery first
2. Then remove the tool.
Very simple to operate please send me an questions or concerns so I can correct any issues that come up! Thank you