LINEBERRY FACTORY CART
STABILIZER TOOL KIT
The original design of
the Lineberry factory carts' front and rear casters allowed for the caster
shaft to slide up and down a little bit inside the caster mount and is the
reason the cart does not sit level. This action took the weight off the ends of
the cart when turning it and allowed the cart to pivot freely. The caster
mounts are located on each end of the cart and bolted onto the cart's wood
frame.
Our stabilizer kit
includes the necessary tools used for drilling and tapping the proper hole size
through the side of both the cart's front and rear caster mounts, also for
cutting the internal thread size required for installation of the extended
point set screw. The set screw when tightened against the caster shaft when
fully extended will prevent the shaft from sliding freely inside the caster
mount. By locking the shaft in the fully extended position the cart will remain
level, and you can lock the cart's front, and rear caster wheels in any
position desired as well. See the listing photo for the location of the set
screw.
Stabilizer Kit
Includes:
· High carbon steel tap and drill bit combo set.
· T-handle tap wrench with self-equalizing
adjustable jaws and spring tension holds T-handle in place.
· 2 ea. Steel cotter pins used to replace
originals when re-installing the wheel casters.
· 2 ea. Black alloy steel extended point set
screws for leveling and locking the caster wheels.
· Step by step instructions on how to install an
extended point set screw in the caster wheel mount for leveling and locking the
carts caster wheels.
We will ship your kit within 1 day after we
receive your order, via USPS First Class mail.