The protectors come in sets of 4. We file down the bumpers in pairs and mark them left and right so they will match when fitted.

 

Each kit comes with a free set of average length solid brass screws but it is advised that you check the thickness of your cases prior to fitting the bumpers to ensure you do not go through to the other side.

 

The bumpers are approximately 3mm thick, 13mm wide and 60mm long (approx.)

 

The two protectors are shaped and filed in pairs so the measurements are approximate.

 

The protectors are completely flat so when seeing which ones fit your case, only measure the flat part of the case ends rather than the whole case width including curves or the protectors will stick out over the curve.

 

All protectors and screws have been coated with a lacquer to help prevent oxidation but you can request without lacquer if you contact us and we will put a set aside for you.