The inner diameter of oil seal is different, and different tool sizes (S-number) are selected. M. L).

The hydraulic cylinder depth is different, and different length tools (120 length) are selected. 180.280.380.500）。

Tool s is suitable for most oil seal inner diameter 22mm-40mm, and the width of oil seal lip is less than 8mm

The auxiliary tool m is suitable for most oil seal inner diameter of 40mm-70mm, and the width of oil seal lip is less than 11mm

Tool L is suitable for most oil seal inner diameter 70mm-165mm, and the width of oil seal lip is less than 14mm

Thickened stainless steel material, tie rod seal torque, oil seal installation tool.

Oil seal installation tool, pull rod seal torque device can buckle the seal into Ω Shape without any sharp angle,

It can be installed in deep hole, make the outer dimension of seal smaller than the inner hole of end cover, and assist oil seal installation. U-type secret

Seal rod seal installation tool is a good assistant to install static seal of oil seal dynamic seal rotating seal in seal installation

During installation, damage caused by touching metal chamfer cannot be performed during installation

After inspection. The pull rod seal can safely cross the sharp angle of all metal grooves, and complete the installation after reset.

Installation steps:

1. place one handle into the socket, and then hang the seal on the bending arm

2. pull the other handle with the right hand, and turn the seal at the same time with the left hand to twist

3. hold the handle tightly, place the seal into the end and carefully fill the seal into the groove

4. release the handle, and pull the twist gear out after the rotary seal rebounds and resets